Advertisement
00 Index and foreword
Handling of electrical equipment
3. Perform a continuity test on the connector.
After drying, leave the wiring harness discon-
nected and perform a continuity test to check for
any short circuits between pins caused by water.
a After the connector is completely dried, blow
the contact restorer and reassemble them.
Handling of connectors used on engine
Slide, lock type
(FRAMATOME-3, FRAMATOME-2)
Disconnection
1. Slide lock (L1) to the right.
2. While pressing lock (L2), pull out connector (1)
toward you.
a In the case that even if lock (L2) is pressed,
connector (1) cannot be pulled out toward
you unless part A floats, float part A with a
small flat-head screwdriver while pressing
lock (L2), and then pull out connector (1) to-
ward you.
00-36
Connection
1. Insert the connector securely until a click is
heard.
(FRAMATOME-24)
Disconnection
1. Slide down lock (red) (L1).
2. While pressing lock (L2), pull out connector (1).
a Lock (L2) is located in the back of connector
(1).
WA200-7
Advertisement
