Advertisement
Type 3
Disconnection
1. While holding the fitting, push body (9) in straight
until sliding prevention ring (8) hits contact
surface (b) at the hexagonal portion on the male
side. (Fig. 10)
2. While keeping the condition of Step 1, push
cover (10) straight until it hits contact surface (b)
of the hexagonal portion on the male side. (Fig.
11)
3. While keeping the conditions of Steps 1 and 2,
pull out whole body (9) to disconnect it. (Fig. 12)
WA200-7
Method of disconnecting and connecting of push-pull type coupler
Connection
1. While holding the fitting, push body (9) in straight
until sliding prevention ring (8) hits contact
surface (a) at the hexagonal portion on the male
side to connect them. (Fig. 13)
00 Index and foreword
00-31
Advertisement
