Using The External Video Source - Eiki LC-120 Owner's Instruction Manual

USING THE EXTERNAL VIDEO SOURCE
TO TURN ON THE PROJECTOR
Connect the projector to an external video source (VCR, Video Camera, Video Disc Player, etc.) using the appropriate
terminals on the rear of the projector (See page 17).
Connect the projector's AC power cord into a wall outlet and press the MAINS switch (located on back of the projector)
to ON (IN) position. The POWER indicator wil ight RED.
CAUTION:
Press the POWER (LAMP) ON/OFF button on the projector (or on the remote contro! uni) to ON. The POWER
indicator wil ight dim and the cooling fan will operate
TO TURN OFF THE PROJECTOR
Press the POWER (LAMP) ON/OFF
indicator will light bright. The cool
ion on the projector (or on the remote control unit) to OFF, The POWER
an will operate for 1 minute after the projector is turned off.
NOTE 1: After you tum off the projector using the POWER (LAMP) ON/OFF button on the projector (or on the remote
control unit) you must w a i t about 30 seconds before you can turn the projector on again.
NOTE 2: TEMPERATURE WARNING INDICATOR flashes red, the projector will automatically turn of.
Wait atleast 5 minutes before turning the projector on.
If the TEMPERATURE WARNING INDICATOR continues to flash, follow the procedures below:
(1). Press POWER (LAMP) ON/OFF button to OFF.
(2). Check the air fiter for dust accumulation.
(3). Remove dust with vacuum cleaner (See air fiter care and cleaning on page 18.)
(4). Press POWER (LAMP) ON/OFF button to ON.
И the TEMPERATURE WARNING INDICATOR still continues to flash, call your authorized distributor or
dealer for service.