Advertisement
Remote control RC-80/RC-80E
BH Operations
1. Connect
the power
plug of the receiver to an AC
outlet.
@ The receiver enters the power standby mode and the
POWER STANDBY indicator lights.
2. Press the POWER key of the remote control unit or the
POWER
key of the receiver.
® The receiver enters the power ON mode.
3. The various functions of the receiver can be operated
with the keys of the remote control unit.
Note for remote control operation
After pressing one of the operation
keys, when
the next
operation is required, press the next operation key firmly after
an approx. 1 second interval.
If the next operation
key is pressed immediately after the
previous key, misoperation may result.
HM Installing
the
batteries
in the
remote
control unit
1. Remove the battery compartment cover.
2. Insert two size "AA"
(R6) batteries confirming
the
correct polarity and close the cover in its place.
Note:
The provided batteries are to be used for checking the operation
of the remote control unit, and they may have a short life. When
the remote unit becomes effective only for short distances or
does not operate properly, replace the batteries with two new
batteries.
ges
8
ee
@ Operating
range
of the remote
control
unit
The operating range of the remote control unit may differ
according to temperature, humidity. or using conditions,
however,
it is defined
approximately
as shown
in the
figure below:
For controlling audio
The signal transmission system
used by this remote contro! unit
is the infrared control system.
For controlling TV and VIDEO sets (U.S.A. and
military models)
KV-D957S
KMT-3027S
KR-V7010 (En)
27
Advertisement
