Table of Contents
Advertisement
Applying labels to the bottom cover:
The new bottom cover assembly is shipped with a kit containing labels of several kinds. Apply those labels
when you replace the bottom cover assembly. For the labels that are not shipped with the new bottom cover,
peel them from the old bottom cover, and adhere them to the new one.
The following illustration shows the location of each label.
1
S/N label
3
CECP label
5 6 7
Asset tags
9
Israel label
11
Indonesia Postel label
1020 Battery
Important notices for replacing a battery
Attention: Lenovo has no responsibility for the performance or safety of unauthorized batteries, and
provides no warranties for failures or damage arising out of their use.
The Lenovo Solution Center program provides an automatic battery diagnostic test that determines if the
battery is defective. A battery FRU should not be replaced unless this diagnostic test shows that the battery
is defective. The only exception to this is if the battery is physically damaged or a customer is reporting a
possible safety issue.
If the Lenovo Solution Center program is not installed on the computer, the customer should download
and install the program to diagnose the battery, before getting a non-physically damaged battery
replaced. Note that the replacement of a physically damaged battery is not covered by the warranty.
Customers can download the Lenovo Solution Center program from the Lenovo Support Web site at:
http://www.lenovo.com/support.
For access, remove this FRU:
•
"1010 Bottom cover" on page 60
2
GEO label
4
GML label (for Windows 10)
8
MCMC label for Malaysia
10
Indonesia rating label
12
Brazil ANATEL label
.
Chapter 8
Removing or replacing a FRU
61
Advertisement
Table of Contents
