Axis M5000-G User Manual page 51

AXIS M5000-G PTZ Camera
The web interface
Meter
Settings here can vary according to device, check the manual of the Z-Wave device.
• Meter type: For example, Electric meter.
• Units: Measuring unit. For example, kWh, W, V, A
• Rate type: For example, import (Consumed measurement)
Meter reading
• Preferred unit: A list of available options will be displayed here.
Reset meter: This operation will reset all accumulated values stored in the meter device. You must first confirm you have read
understood the actions of resetting the meter.
Notification
Settings here can vary according to device, check the manual of the Z-Wave device.
Supported notifications: Details of supported notifications will be listed here.
Fetch notification report:
• Type: Available types will display here.
• Event: List of configured events will display here.
Control notification status:
• Type: Available types will display here.
• Activated: Current status is displayed here.
Wake-up
Allows a sleeping node (one that sends data only when it needs to) to receive data by notify an always-listening device that it is
awake and ready to receive data, does not require the node to be manually triggered.
Maximum interval: Time in seconds, for example 86400 seconds.
Minimum interval: Time in seconds, for example 600 seconds.
Default interval: Time in seconds, for example 14400 seconds.
Interval step: Time in seconds, for example 600 seconds.
Configure wake-up interval:
• Wake-up interval: The number of seconds it takes before the gateway will synchronize with the device, for example
4200 seconds. The Wake-up interval must
the value needs to be within the range defined by the minimum and maximum interval, see the examples given.
• Node ID: The ID of the node to be notified on wake-up, use 255 to broadcast to all nodes.
You can add a Z-Wave device to the provisioning list with SmartStart inclusion. A Z-Wave device added to the provisioning list is
automatically added to the device management list as soon as the device is powered on.
Note
A Z-Wave device will not be removed from the device management list if you remove it from the provisioning list.
Add device information: When a device is found follow the instructions as per your Z-Wave device installation manual.
Manually add Device name and Device location, these will be displayed in the Device management table.
: Hover over a device in the list to show the icon. Click the icon to delete it from the list.
must be devisable by the number of seconds in the interval step. Furthermore
must
51