Using Super cool and DynaCool
DynaCool
When the DynaCool function is not
switched on, the natural circulation of
air in the appliance will cause different
temperature zones in the fridge zone,
as the cold, heavy air will sink to the
lowest section of the appliance. You
should bear this in mind when placing
food in the appliance (see "Storing
food in the refrigerator section").
However, if you are storing a large
amount of similar food in the
refrigerator at any one time, e.g. after
your weekly shop, it is a good idea to
turn on DynaCool. This way you can
distribute the temperature on all the
adjustable shelves inside the
appliance more evenly so that all the
food in the fridge zone will be chilled
to about the same degree.
The temperature is set as normal with
the temperature control.
Also switch on the DynaCool function
when:
- The ambient temperature is high
(above approx. 35 °C)
- The humidity levels are high (e.g. in
the summer)
The fan will always switch on
automatically when the compressor
switches on.
Tip: As the energy consumption
increases when DynaCool is
switched on, you should turn the
DynaCool function off again under
normal conditions.
To save energy, the fan switches off
automatically whilst the door is open.
44
Switching DynaCool on and off
Touch the OK sensor control on the
control panel.
will appear in the display.
Touch OK.
Use the sensor control to scroll to
the symbol.
Touch OK.
When the DynaCool function is
switched on, a dot appears in the
upper corner of the display
Use the sensor controls to scroll to
the temperature you want and touch
OK.
.