Table of Contents
Advertisement
Problem solving guide
Message
The symbol lights up
in the start display and
a buzzer sounds.
lights up in the
display and an alarm
also sounds.
lights up red in the
display, a fault code F
with numbers appears
and an alarm also
sounds.
70
Cause and remedy
The charcoal filter replacement indicator in the
start display reminds you to replace the charcoal
filter.
Replace the charcoal filter in the holder (see
"Cleaning and care – Replacing the charcoal filters
(optional accessory)") and confirm that the
charcoal filter has been replaced by touching the
OK sensor control.
The symbol will go out on the start display.
The door alarm has been activated.
Touch OK.
The alarm will stop and the
Close the appliance door.
There is a fault.
To switch the alarm off touch in the display.
Contact your Miele dealer.
To report the fault you need the fault code and also
the model number and serial number of your
appliance. You can access these in the display.
To do this touch in the display.
The appliance data required will be shown in the
display.
Confirm with
OK
the fault code will be shown again in the display.
The appliance can be switched off directly from the
fault code display.
Touch .
There is an appliance fault: this display always has
priority over any settings which have just been
selected.
An appliance fault has priority over any current door
and/or temperature alarms displayed.
symbol will go out.
to exit the information display and
Advertisement
Table of Contents
