Table of Contents
Advertisement
8.4 Command Control via the Network
commands.
Communication Port
The following two ports are assigned for the command control.
(Network Control Port1 (Port: 23))
(Network Control Port2 (Port: 9715))
NOTE
Command Control Settings
48)
Example: If the IP address of the projector
is set to 192.168.1.10:
1) Enter "http://192.168.1.10/" into the
address bar of the web browser, and
select Projector Web Control from the
selection window.
2) Enter your user name and password,
and then click the [OK].
3) Click the [Port Settings] on the main
menu.
4) Click the [Enable] check box to open
Network Control Port1 (Port: 23) to use
for the [Authentication] setting when
the check box.
5) Click the [Enable] check box to open
Network Control Port2 (Port: 9715)
check box for the [Authentication]
otherwise clear the check box.
8. Other Functions
[Enable] check box
[Enable]
97
Advertisement
Table of Contents
