Panasonic KX-W1500 Service Manual page 17

Screw Card Holder |
Front Support
——_f____--—____ 2
3
/ Seng,
Ribbon > 6.
8
\
9
E-ring
Daisy Drive Screw Carrier Board
Unit
4.1.4 Daisy. Drive Unit
. Remove the Front Support and the Card Holder
by removing the screw.
. Remove the E-ring and the Drive Cam.
. Remove the screw from the. Ribbon Sensor
Board.
Remove the screw from the Carrier Board.
Remove the spring.
Remove the Clip from the Slide Shaft.
. Remove the Slide Shaft by pulling it to the front.
. Carefully lift off the Daisy Drive Unit, Carrier
Board and Ribbon Sensor Board together.
Replacement is done in the reverse order.
4.1.5 Hammer and Hammer Solenoid
Spring
Hammer Plastic Washer
1.
E-ring 2.
Remove the E-rings from the Hammer Pivot
Shaft.
Slide the Shaft to the left and remove the Ham-
mer with the plastic washer and spring.
3. Remove the 2 screws from the Hammer Solenoid.
. Remove the Solenoid.
5. Unsolder the Solenoid leads from the Carrier
Board.
Replacement is done in the reverse order.
4.1.6 Daisywheel Motor
S46:
. Remove the E-ring @ from the Daisywheel Gear
Shaft.
2. Pull the Daisywheel Gear forward to remove.
3. Remove the screw from the Daisywheel Motor.
4. Remove the E-ring ® from the Daisywheel Shaft
bushing.
5. Remove the Bushing.
6. Remove the Motor.
7. Unsolder the Motor leads from the Carrier Board.
Replacement is done in the reverse order.
During replacement check the following:
@ Make sure that leads match with indicated color
as shown in the figure.
@ Make sure that the marks on the two Daisy-
wheel Drive Unit Gears are aligned.