Table of Contents
Advertisement
USING THE STILL FEATURE
When "STILL"
Button is pressed during playback, a
still picture can be seen.
To start again press "STILL"
"STILL" Button
Button and playback will be resumed.
NOTE:
There will be some
noise (interference)
in the
still picture.
USING THE MEMORY FEATURE
When
the tape
counter
indication
appears
in the
viewfinder, a tape that is being rewound automatically
"DISPLAY" Button
stops when the Counter reads approximately
0000''.
"RESET"
Button
This is useful if there is a section of tape you want to
review immediately after recording or if you want to.
"REW"
Button
return to the same point several times in a row.
"STOP"
Button
1. Press ''DISPLAY" Button. (The 4-digit tape counter
appears in the viewfinder.)
2. Start playing or recording a tape.
3. At the point you
want
playback
to start,
press
"RESET" Button to reset the Counter to "0000".
4. Continue to play or record.
5. Press "STOP" Button.
6. Press '"REW" Button.
The tape will be rewound to
the preselected point, at approximately "0000" indi-
cation.
NOTE: The tape will also stop approximately at '0000'
during fast forward mode.
OPERATING FINS. iaccenss tease ececescessstome vans
* After you have finished using the Camera/ Recorder,
remove the cassette and the power source from the
Camera/Recorder and attach the Lens Cap.
* Always
reset the "COUNTER"
to '0000'
when
starting to use a cassette.
Make
a note on the
cassette what number the ""COUNTER" reads when
the recording is finished if less than the full cassette
is used.
This allows you to record more program
materials at the end of the first recording.
Any other
locations on the tape can be noted on the cassette
label also, if desired, so you can quickly locate them
later.
27
Advertisement
Table of Contents
