Advertisement
SL-DL1
e Offset adjustment of tonearm and servo gain
DC electronic voltmeters (VTVM).
1mm pitch record.
Flat head screwdriver (small).
Phiplips head screwdriver (small).
Hexagon wrench (M1.5).
Condition of the set
Remove the dust cover and surface plate.
(Refer to "Disassembly instructions."')
Turn the reset switch (S307) ''on'" by pressing it with tape. (Fig. 21)-
Remove the rear cover.
(Refer to 'Disassembly instructions.)
OPO
NS
RON>
Note:
The tonearm does not operate with the turntable removed.
Adjustment method
@ Turn the power switch '"'on" and move the tonearm towards the center of disc
by pressing the start button.
@ Press the cueing button
to check
that the clearance between
the cartridge
stylus and the guide rail is about 26mm.
@) If the clearance
is incorrect, adjust the lift height by turning the adjusting
screw with a flat head screwdriver.
— Turn clockwise when excessive (> 26mm).
— Turn anticlockwise when insufficient (< 26mm).
tightened
up.
So, loosen the adjusting screw before making the above
Adjustment of arm
adjustment.
lift height
(See Fig. A)
Guide
rail
About
Cartridge
@ Turn the power switch "'on'' and move
the tonearm towards the center of disc
V groove
by pressing the start button.
@) Make sure that the arm center is align-
ed with the V groove of the lift lever.
@) Make sure that the arm ebase is in
parallel with the arm.
(Check the clearance between (A) and
in Fig. B.)
@) If the arm base is not in parallel with
the arm, adjust it by turning the offset
angle adjusting screw.
Offset angle adjust-
ment of tonearm
(See Fig. B)
Offset angle
adjustment
screw
Advertisement
