Sony MVS-3000A System Startup Manual page 54

3
Select the keyer, key source, and key type.
a In the Flexi Pad, press the [KEY ADJ] button,
turning it on.
b Press the [M/E1] button, turning it on.
c Press the [KEY1] button, turning it on.
d Press the [LUM] button, turning it on.
e Press the [AUTO SEL] button, turning it on.
This uses the signals assigned in pairs as the key
source.
KEY ADJ button
M/E1 button
LUM button
MVS-6520/3000A diagram shown.
On the MVS-3000, the [DME1] and [DME2] buttons are not
displayed.
On the MVS-6530, the [M/E2] button is also displayed.
Key source (assigned in signal pair) for title video
4
Insert the key.
a Check the post-insertion video on the monitor
assigned beforehand for key preview output.
For details about key preview output, refer to the
User's Guide.
b Press the [KEY1 ON] button in the transition
control block.
54
Inserting Titles (Keys)
KEY1 button
AUTO SEL button
Flexi Pad
Memo
To insert the key using an auto transition, press the
[KEY1 TRANS] button.
KEY1 ON button
KEY1 TRANS button
Transition control block
5
Insert keys 2 to 4.
a Repeat step 1 and select the key 2 image.
Press the [KEY2] button on the 1st row of the cross-
point control block and select the image in the 2nd
row.
b Repeat step 3 to configure key 2.
Press the [KEY2] button on the Flexi Pad, and set
the key source and key type.
c Repeat step 4 to insert key 2.
Press the [KEY2 ON] button or [KEY2 TRANS]
button on the transition control block.
d Configure key 3 and key 4, as required.
Key 2
Key 1