Engine Oil And Oil Strainer - Yamaha ZUMA 125 2020 Owner's Manual

Periodic maintenance and adjustment

Engine oil and oil strainer

The engine oil level should be checked
before each ride. In addition, the oil
must be changed and the oil strainer
cleaned at the intervals specified in the
periodic maintenance and lubrication
chart.
To check the engine oil level
1. Place the scooter on the center-
stand. A slight tilt to the side can
result in a false reading.
2. Start the engine, warm it up for
several minutes, and then turn it
off.
3. Wait a few minutes until the oil set-
tles, remove the oil filler cap, wipe
the dipstick clean, insert it back
into the oil filler hole (without
screwing it in), and then remove it
again to check the oil level.
TIP
The engine oil should be between the
minimum and maximum level marks.
1
2
1
3
1. Engine oil filler cap
2. Minimum level mark
3. Maximum level mark
4. If the engine oil is below the mini-
mum level mark, add sufficient oil
of the recommended type to raise
it to the correct level.
5. Insert the dipstick into the oil filler
EAUT4163
hole, and then tighten the oil filler
cap.
To change the engine oil and clean
the oil strainer
1. Start the engine, warm it up for
several minutes, and then turn it
off.
2. Place an oil pan under the engine
to collect the used oil.
3. Remove the engine oil filler cap
and the engine oil drain bolts A and
B to drain the oil from the crank-
case. NOTICE: When removing
the engine oil drain bolt B, the
O-ring,
and oil strainer will fall out. Take
care
parts.
1. Engine oil drain bolt A
7-10
compression
not to lose
[ECAT1022]
1
2
3
4
5
spring,
6
these
7
8
9
1
10
11
12
13
14