Table of Contents
Advertisement
Disturbance
Removable streaks
are located on glasses,
glasses with a metallic
appearance
and cutlery.
Traces of rust on surfaces
plug.
There are cleaning residues
in the detergent
chamber or in the
tab collecting tray.
Refill indicator for
Special salt lights up.
Cause and troubleshooting
Place dishes in the upper dish rack so that the tab
1.
drip tray is not blocked by dishes.
→
"Putting away the dishes", page 35
The dishes are blocking the cleaner lid.
Do not place dishes or air fresheners in the tab drip
2.
tray.
Dishes have been pre-cleaned too much. The sensors
determine a weak program flow. Stubborn dirt
sometimes cannot be removed.
Only remove large food residues and do not pre-
▶
wash the dishes.
Adjust the sensitivity of the sensors.
▶
→ "Sensors", page 11
Cutlery is not sufficiently rust-resistant. Knife blades
are often more severely affected.
Use rust-resistant dishes.
▶
Cutlery also rusts if rusting parts are washed with it.
Do not wash rusty parts.
▶
Salt content in the rinse water is too high.
Remove any spilled special salt from the rinsing
1.
container.
Tighten the cap of the special salt container tightly.
2.
Spray arms were blocked by crockery and the
detergent was not rinsed out.
Make sure the spray arms are not blocked and
▶
can rotate freely.
The detergent chamber was damp when the detergent was
filled.
Only pour cleaner into a dry cleaner chamber.
▶
Special salt is missing.
Fill with special salt → Page 28 a.
▶
Sensor does not recognize special salt tablets.
Do not use special salt tablets.
▶
Troubleshootingde
55
Advertisement
Table of Contents
