Kreg KFPCHB Manual

1
4
WOODWORKING KIT
STEP 1:
Set Up Your Pocket-Hole Jig
Scan the QR to watch a video for this step
A
A
Use Material Thickness Gauge / Hex Wrench to measure material thickness (¾").
B
Set jig material thickness to ¾".
Note: You can use most Kreg Pocket-Hole Jigs for this project. Be sure to set up and
use your jig according to the manufacturer's instructions, and follow this guide for
proper hole placement.
C
Set drill bit stop collar to ¾" (loosen and tighten stop collar with Hex Wrench).
Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of
WARNING:
California to cause cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection. For more information
go to www.P65Warnings.ca.gov/wood.
Improper assembly or excessive weight applied to the finished product could result in injury. Follow all instructions provided
WARNING:
for assembly. Kreg is not responsible for injuries as a result of improper assembly or use.
Always wear personal protective equipment certified as such, including safety glasses, hearing protection, and respiratory
WARNING:
protection. When using a power tool, always follow the manufacturer's personal protection equipment requirements. Gloves are
recommended for handling unfinished wood products.
3
2
CORNHOLE BOARDS
B
6
12
10
5
9
Base Kit
1 Side Rail
2 Cross Brace
3 Top
4 Leg Brace
5 Leg
6 Cornhole Board Hardware
C
13
7
14
11
8
Included in Bundle
7 Pocket-Hole Jig 520PRO
8 Versa-Grip Clamp - 24"
TM
9 2" Classic Face Clamp
10 Material Thickness Gauge
11 #2 Driver Bit
12 Easy-Set Drill Bit and Stop Collar
13 2 1/2" Pocket-Hole Screws
14 1 1/4" Pocket-Hole Screws
BEFORE YOU
GET STARTED
We want to make sure
have you the guidance
and resources you
need to be successful
with this project.
Simply scan the QR
code below for tips and
tricks on setting up
your jig, drilling pocket
holes, and more.