Advertisement
STEP 4:
Assemble Frame
Scan the QR to watch a video for this step
A
E
A
Optional: Workpiece edges and pocket holes can be sanded
prior to assembly.
B
Align edge of first Cross Brace with guide lines of both
Side Rails. Important: Ensure all pocket holes are facing the
correct direction, as indicated in photo B.
C
Clamp side rails to first Cross Brace, checking to make sure
alignment with guide line is consistent.
Important: Position pieces so that pocket-holes point in
toward the center.
D
Use #2 driver bit to drive 1 ¼" pocket-hole screws into
Cross Brace.
STEP 5:
Attach Top to Frame (x2)
Scan the QR to watch a video for this step
A
A
Place Frame Assembly on Top and position so that corners
of Frame Assembly align with guide lines located at each
corner of Top.
B
Clamp the Top and Frame Assembly to the work surface.
C
Use #2 driver bit to drive 1 ¼" pocket-hole screws into Cross
Braces.
Tip: Adjust drill clutch for driving screws. Do NOT use an
impact driver, as this may lead to over-driven screws or
stripped screw heads.
B
F
B
C
G
Tip: Adjust drill clutch for driving screws. Do NOT use an
impact driver, as this may lead to over-driven screws or
stripped screw heads.
E
Place second Cross Brace so it aligns with next guide line
indicated on Side Rails.
F
Use #2 driver bit to drive 1 ¼" pocket-hole screws into the
Cross Brace.
G
Place remaining Cross Braces so they align with remaining
guide lines and attach with #2 driver bit and 1 ¼" pocket-
hole screws.
H
Ensure assembled frame matches photo H.
I
Repeat A - H for second Frame Assembly.
C
D
Attach the Cross Braces by driving 1 ¼" pocket-hole screws,
starting with the pocket holes in one corner then moving
to the opposite corner. After all four corners are attached,
attach remaining Cross Braces with pocket-hole screws.
E
Repeat A - D for second Top and Frame Assembly.
D
H
D
Advertisement
