Advertisement
STEP 6:
Assemble and Attach Legs (x4)
Scan the QR to watch a video for this step
A
E
A
Align edge of Leg Brace with guide line on Leg as shown in
photo A.
B
Use #2 driver bit to drive 1 ¼" pocket-hole screws into Leg
Brace.
Tip: Adjust drill clutch for driving screws. Do NOT use an
impact driver, as this may lead to over-driven screws or
stripped screw heads.
C
Repate A - B for second Leg.
D
Arrange included Bolt, Washers, and Nut as shown
in photo D.
B
A
C
E
Insert the rounded end of Leg Brace into Frame and line
up the hole in the Frame with the hole in the Leg. Slide bolt
through bolt hole and secure using the washers and nut.
Note: Place one washer between the bolt head and Side Rail,
Side Rail and Leg, and the nut and Leg. Tighten nut using a
pair of combination or adjustable wrenches.
Tip: Avoid under- or over-tightening the nut, so the Leg
Assembly moves freely but stays in place when folded up.
F
Repeat steps for second assembly.
STEP 7:
Customize it!
Scan the QR to watch a video for this step
Once you're finished adding your own decorative touches,
take a photo and post it with the #builtwithkreg hashtag to
show your work and see what others are building with Kreg.
NOTE: For best results, seal top and edges of cornhole boards.
The material used is a composite that can be vulnerable to
water damage if not properly sealed. For tips on how to apply
sealer to edges, please visit: https://learn.kregtool.com/learn/
make-painted-plywood-edges-look-great/.
D
Advertisement
