Parking The Machine - Case 3 Series Operator's Manual

INTRODUCTION, SAFETY, PLATES AND DECALS

PARKING THE MACHINE

When parking the machine, some precautions are
necessary.
Move the machine to a level and firm ground, away
from any soft ground, excavations or poorly shored
cavity.
Lower the loader attachment to the ground.
Place the backhoe attachment in the road travel
position.
Place the direction-of-travel lever and gearshift lever
in neutral position.
Immobilize the machine by means of the parking
brake.
10
Raise the stabilizers completely and lock them
mechanically.
Stop the engine and remove the starter switch key.
Release the hydraulic pressure by operating the
control levers in all directions. On hydraulically con-
trolled machines, turn the key to ON and release the
pressure by moving the hydraulic control levers in
all directions.
Place some wedges under the wheels so as to pre-
vent the machine from moving.
Make sure that the door and the engine guard are
correctly fastened and lock the operator's compart-
ment door.
Check that no part of the machine is protruding onto
the public highway. If this cannot be avoided, install
signs in compliance with the relevant regulations.
1-13