Woods SB84.40 Operator's Manual page 30

8. Attach the switch box (item 1) on the lever in a con-
venient position using clamp (item 5) and two 1/4
NC x 3/4" bolts and lockwashers (items 3, 4).
NOTE: Tighten the bolts just enough to secure the
clamp and the switch box on the lever. Do not
over-tighten to prevent damage..
Figure 28. Mount Switch Box
9. Run the black ground wire (item 9) to any grounding
screw on the tractor.
30 Assembly
MAN1369_2023-10.indd 30 MAN1369_2023-10.indd 30
10. Locate a wire on the tractor that is an accessory
power source, that is, only having current when the
ignition is switched on. Connect the fuse wire (item
11) to that switched wire using the tap connector
(item 13).
■ For continued protection against risk of fire re-
place ONLY with a fuse of the same type and
having the same electrical rating
11. Install the protective loom on the two power wires
(red and black) and cut off the excess. Apply
electrical tape to hold enclosures closed. Fasten ev-
erything in place on the tractor with nylon tie wraps.
12. Make sure to lower and rise the snow blower and
rotate the chute into all positions to see if the elec-
tric harness is long enough and do not interfere with
any component.
NOTE: If the functions are opposite to the direction
of the switch, only reverse the red wire and the
black wire on terminals A and D of the switch.
■ For continued protection against risk of fire, re-
place ONLY with a fuse of the same type and
having the same electrical rating.
Figure 29. Electrical Diagram
CAUTION
CAUTION
MAN1369
( 10/31/2023 )
11/1/23 4:20 PM 11/1/23 4:20 PM