Woods SB84.40 Operator's Manual page 29

NOTE: Make sure to leave enough slack in the
hoses to allow for free movement as the discharge
chute rotates from side to side.
Figure 25. Assemble Hydraulic Hoses
Optional Electric Chute Deflector
Figures 26 - 29
1. Remove the manual chute deflector by straighten-
ing and removing cotter pins.
2. Figure 26: Assemble the longer clevis (item 1) to the
base end of the actuator (item 2) and assemble the
shorter clevis (item 3) to the rod end of the actuator
using 1/2 NC x 2-1/2 bolts and 1/2 NC nylon insert
nuts (items 4, 5).
NOTE : Be sure to attach the actuator as shown in
the figure to avoid damaging the electric cylinder.
Figure 26. Attach Electric Actuator
MAN1369
( 10/31/2023 )
MAN1369_2023-10.indd 29 MAN1369_2023-10.indd 29
3. Assemble the actuator to the discharge chute using
pins (item 7) and secure with a 3/16 x 1-3/4 spring
pin (item 6) and a 4mm x 80mm hair pin (item 8) on
each.
4. Connect the actuator wire's female connector (item
12) to the electric actuator (item 2). Protect the wires
by enclosing in loom (item 14) and secure with wire
ties.
NOTE: Make sure to leave enough slack in the
wiring to allow for free movement as the discharge
chute rotates from side to side.
5. Install the snow blower on the tractor by following
the instructions of the Operation Section.
6. Choose the location for the switch on a convenient
control lever on the tractor. Connect wires to the
switch as shown in the wiring diagram.
• Black ground wire (item 9) to terminal "C".
• Red wire with fuse (item 11) to terminal "B".
• Red and black wires from actuator to terminals
"A" and "D".
NOTE : If your tractor is not equipped with a valve
lever, it is possible to position the switch in another
place so that it is easily accessible but it must not
interfere with the controls already present on the
tractor.
Figure 27. Attach Switch Box
7. Figure 27: Insert the switch (item 4) in the switch box
(item 2) and secure with nuts (items 1, 3). Attach the
rubber cap (item 5) on the switch.
Assembly 29
11/1/23 4:20 PM 11/1/23 4:20 PM