Table of Contents
Advertisement
DEALER SET-UP INSTRUCTIONS
Assembly of this snow blower is the responsibility of
the Woods dealer. It should be delivered to the owner
completely assembled, lubricated and adjusted for nor-
mal conditions.
The snow blower is shipped partially assembled.
Assembly will be easier if components are aligned
and loosely assembled before tightening hardware.
Recommended torque values for hardware are shown
in the Bolt Torque Chart.
Select a suitable working area. A smooth, hard surface,
such as concrete, will make assembly much quicker.
Open parts boxes and lay out parts and hardware to
make location easy. Refer to illustrations, accompany-
ing text, parts lists and exploded view drawings.
■ To avoid serious injury or death: Read and un-
derstand the Safety Rules at the beginning of
this manual before assembly. Support the snow
blower securely during assembly.
Preparation
1. Remove the top and sides of the crate. Carefully
cut bands and straps securing the chute assembly,
driveline and SMV sign and set aside.
2. Using a lifting device with a capacity of at least 1500
lb., support the snow blower and remove hardware
attaching it to the skid.
3. Raise the snow blower, slide the skid out and lower
the snow blower to the ground.
SMV Sign Installation
Figures 15 and 16
1. Remove the 1/4 NC x 1" bolt, the flat washer and
the 1/4 NC nylon insert nut (items 1, 2, 3) that fixes
the sign (item 4) to the frame. Save the hardware.
Figure 15. SMV Sign Preparation
MAN1369
( 10/31/2023 )
MAN1369_2023-10.indd 25
MAN1369_2023-10.indd 25
ASSEMBLY
WARNING
2. Install the sign support (item 1) on the snow blower
with two 1/4 NC x 1" bolts, flat washers and 1/4 NC
nylon insert nuts (items 2, 3, 4).
Figure 16. SMV Sign Installation
3. Using the hardware previously removed, attach the
SMV sign (item 5) with two 1/4 NC x 1" bolts, flat
washers and 1/4 NC nylon insert nuts (items 6, 7,
8).
4. Remove the black protective film from the SMV sign.
Chute Installation with Manual Rotator
Figures 17 - 20
1. Figure 17: Insert the 1-11/16" plastic bushing (item
1) in the worm support bracket (item 2)and insert
the long end of the rotation worm (item 3).
2. Insert the 1-5/16" plastic bushing (item 4) in the
welded tube of the snow blower (item 5).
3. Place the worm support (item 2) and the support
spacer (item 10) under the snow blower's left upper
plate (item 6).
4. Figure 18: Apply grease on the chute base and
around the snow blower chute ring. Install the chute
(item 1) with the four retaining plates (item 3), four
spacers (item 2) and eight 1/4 NC x 3/4" bolts and
flanged nuts (items 4, 5). Tighten securely.
NOTE: Use high quality grease designated "ex-
treme pressure" and containing molybdenum
disulfide. The label may specify "Moly EP".
Assembly 25
11/1/23 4:20 PM
11/1/23 4:20 PM
Advertisement
Table of Contents
