Woods SB84.40 Operator's Manual page 26

5. Insert the rotation tube (item 7) in the worm assem-
bly, aligning the holes, and insert a #10-24 x 1"
socket head capscrew (item 8), making sure the
screw sinks into the rotation worm (item 3). Secure
with a #10-24 nylon insert nut (item 9).
Figure 17. Chute Preparation
6. Figure 19: Install the rotation bracket (item 1 on the
right arm of the three point hitch with two 3/8 NC x
1-1/4" bolts, lockwashers and nuts (items 2, 3, 4).
Tighten securely.
7. Attach the handle support bracket (item 5) to the
rotation bracket (item 1) with a 3/4 NC x 1-1/4" bolt,
lockwasher and nut (items 6, 7, 8) making sure to
orient the bracket as shown.
8. Insert the handle support (item 9) in the bracket
(item 5) and adjust the height of the support accord-
ing to your needs and secure in place with a 3/8 NC
x 1/2" square head setscrew (item 10).
9. Insert the grommet (item 11) in the handle support
(item 9).
10. Figure 20: Insert the rotation handle (item 1) in the
handle support (item 4) and in the rotation tube.
Select desired length, align nearest holes and se-
cure with the 4 mm x 80mm hairpin (item 2). Install
the plastic handle (item 3).
11. Figure 19: Once the snowblower is attached to the
tractor, adjust handle position and height to ensure
comfort and safe operation. Tighten setscrew (item
10) on the handle support as well as the 3/4 NC x
1-1/2" bolt, lockwasher and 3/4 NC nut (items 6, 7,
8).
26 Assembly
MAN1369_2023-10.indd 26 MAN1369_2023-10.indd 26
Figure 18. Chute Installation
Figure 19. Handle Support Assembly
12. Figure 20: To insure the manual rotator functions
properly, position the handle support (item 4) as
close as possible to the top link mounting point of
the three point hitch while making sure it does not
come into contact with the operator's seat when the
snowblower is fully raised.
13. Tighten all bolts to the specifications in the Bolt
Torque Chart at the end of this manual.
MAN1369
( 10/31/2023 )
11/1/23 4:20 PM 11/1/23 4:20 PM