Table of Contents
Advertisement
Remove the bolts (item 2) and reinsert them in the ap-
propriate hole according to the following:
•
On level paved surfaces - Use the lower holes.
•
On uneven surfaces or gravel - Use the middle
or upper holes.
7. Tighten mounting bolts and nuts (2) per specifica-
tions in the Bolt Torque Chart.
DESCRIPTION
Gearbox
Drive chain
and after each operation
Drive shaft
24 hours of operation
Bearings
24 hours of operation
Driveline
22 Owner Service
MAN1369_2023-10.indd 22
MAN1369_2023-10.indd 22
Figure 12. Lubrication
INTERVAL
Check oil level. If needed, add extreme pressure oil, SAE 80W90
Monthly
gear oil or equivalent
Once a year
Replace Oil.
4 hours
Lubricate with chain saw lubricant.
Grease at the shear plate and the grooved section with the grease
fittings. Use a Shell Gadus S5 V100 grease or equivalent.
Grease each auger and drive shaft bearings and the grease fitting of
the shear plate. Use a Shell Gadus S5 V100 grease or equivalent.
Grease each universal joint. Separate the sliding parts and cover
8 hours
each with grease.
16 hours
Oil the quick connect yokes.
Lubrication
Figure 12
IMPORTANT: Perform all the maintenance section
without taking into account the hours given in the fol-
lowing cases:
•
At least once a year if the snow blower is used
less than 20 hours annually.
•
After each storage period.
•
After each wash.
REQUIRED LUBRICATION
MAN1369
( 10/31/2023 )
11/1/23 4:20 PM
11/1/23 4:20 PM
Advertisement
Table of Contents
