Woods SB84.40 Operator's Manual page 27

Figure 20. Rotator Handle Assembly
■ To avoid personal injury, check the full lifting
range of the snowblower, to ensure that the
chute rotation handle is clear of the operator's
area when the snowblower is in raised position.
Chute Installation with Hydraulic Rotator
Figures 21 - 23
1. Figure 21: Place the hole identified "POSITION"
over the indentation in the housing.
2. Apply grease on the chute base and around the
snowblower chute ring and install the chute with the
four retaining plates (item 1), eight 1/4 NC x 3/4"
bolts and eight serrated flange nuts (items 2, 3). Do
not tighten immediately.
3. Attach the rotation bracket (item 5) in the slot on the
left side of the housing with a 1/2 NC x 1-1/4'' hex.
bolt and 1/2 NC serrated flange nut (items 6, 7).
4. Place the spacer ring (item 8) on the 13/16" hole of
the housing; insert the pivot bushing (item 9) in the
bell crank (item 10) and slide the bell crank between
the flat bars of the rotation bracket (item 5).
MAN1369
( 10/31/2023 )
MAN1369_2023-10.indd 27 MAN1369_2023-10.indd 27
CAUTION
Figure 21. Hydraulic Rotator Preparation
5. Attach the other end of the bracket and the bell
crank (fig. 7, items 5-10) in the 13/16" hole of the
housing with the 3/4" NC x 5" hex. bolt, lockwasher
and 3 nut (fig. //, items 1, 2, 3) in the exact order
shown. Tighten securely.
Figure 22. Hydraulic Rotator Installation
6. Grease generously both holes of the push arm (item
17) and install one end under the flat bar welded
on the base of the chute and secure with a 1/2'' x
1" shoulder screw, two 1/2" flat washers, a 3/8" flat
washer and a 3/8 NC stover nut (items 14, 15, 16,
18) in the exact order shown. Tighten leaving some
movement to the mechanism.
Assembly 27
11/1/23 4:20 PM 11/1/23 4:20 PM