Table of Contents
Advertisement
WPIR-EXT
6. Detector Installation
Important! Before installing the WPIR-EXT, read "Select mounting location" section carefully.
1. The detector must be installed in such manner
that the intruder is most likely to cross the
detection area from side to side.
3. Draw metal bracket holes on the wall, leaving
15cm from all sides, for easy installation and
maintenance.
5. Install the detector unit on the metal bracket.
Adjust the detection beam to reach the best
7.
detection range
Adjustments).
Edition Date: 26.07.2021
(refer to Part 7 "Settings &
After detector closure, the detector starts calibration process.
Do not stand in detector's range during this period of 3 minutes.
After this period, the detector is ready for operation.
Installation Instructions/User Manual
2.
The detector must be installed at height of 0.8m
to 1.5m
4. Install the metal bracket on the wall or a pole
using either mounting screws or Jubilee
clips/metal bands.
6. Screw the detector unit to the back metal bracket.
8. Close the detector cover screwing the bottom
screw.
8
Doc ID: I-200478
Advertisement
Table of Contents
