Table of Contents
Advertisement
WPIR-EXT
7. Discovery & Enrollment Process
1. Open the detector unscrewing the bottom screw.
2. Unscrew the detector unit from the back metal bracket and
remove the detector from the bracket by tilting it.
3. Remove the battery cover
4. Discover the WPIR-EXT detector from the SPC control panel or
from the keypad.
To discover the WPIR detector from the SPC control panel:
I.
In the SPC browser, select Configuration>Wireless
and click Enroll New Sensor.
II.
Open the detector and insert the batteries taking
care to observe correct polarity (+/-).
Inserting the batteries starts the discovery process
from the device.
III.
Enroll the device by configuring the Description,
Zone, Zone Type, and other settings in the SPC
system.
OR
To discover and enroll the WPIR detector from the keypad:
I.
On the keypad, select
WIRELESS>SENSORS>ADD>ENROL.
The keypad displays the ADD screen with a
flashing ENROL DEVICE message.
II.
Open the detector and insert the batteries taking
care to observe correct polarity (+/-).
Inserting the batteries starts the discovery process
from the device.
The keypad displays the FOUND SENSOR
message.
III.
Click OK.
IV.
You can now enroll the device by configuring the
AREA, ZONE TYPE and ZONE settings.
V.
Click OK.
The keypad displays the UPDATED message. The WPIR-EXT is
now enrolled on your SPC system.
Edition Date: 26.07.2021
Installation Instructions/User Manual
9
Doc ID: I-200478
Advertisement
Table of Contents
