Data Storage; Automatic Stability Control - Xylem WTW Cond 3310 Operating Manual

Operation
24
Menu item
System / Interface /
Output format
System / Interface /
Decimal separator
System / Interface /
Output header
System / Clock
System / Service infor-
mation
System / Reset

4.3.2 Data storage

This menu contains all functions to display, edit and erase stored mea-
sured values and calibration records.
Note
Detailed information on the memory functions of the Cond 3310 is
given in section 4.5.

4.3.3 Automatic Stability control

The function, automatic Stability control (AutoRead) continually checks
the stability of the measurement signal. The stability has a considerable
impact on the reproducibility of measured values.
You can activate or switch off the automatic Stability control function
(see section 4.4.4).
The measured parameter flashes on the display
 as soon as the measured value is outside the stability range
 when you switch over between the measured parameters with <M>.
 when the automatic Stability control is switched off.
Setting Explanation
ASCII Output format for data
CSV transmission
For details, see section 4.6
Dot (xx.x) Decimal separator
Comma (xx,x)
Output of a header for Out-
put format: CSV
Time Settings of time and date.
Datum For details, see section
Date format 4.2.4
Hardware version and soft-
ware version of the meter
are displayed.
- Resets the system settings
to the default values.
For details, see section
4.8.2
Cond 3310
ba75803e08 10/2017