Table of Contents
Advertisement
Handling and Safety Instructions
1 Handling and Safety Instructions
Depending on the operating conditions, the housing temperature can exceed 60 °C.
There is a risk of injury!
Handle with care! The housing, especially heat sinks can have sharp edges. There is
a risk of injury!
EMC conformity according to EN/IEC 61000-6-2:2005 is qualified for cable lengths ≤
30 m.
Electrostatic discharge at unshielded I/O connectors can lead to unexpected events
or data errors for the corresponding interface.
Electrical installation should be executed without power applied to the device and
connected devices.
Only open if advised by IMAGO!
Warranty void if warranty seal is removed or broken.
Please take special note of the voltage range which may be applied to the device.
Otherwise, permanent damage to the device may result!
Air Circulation
When mounting the device within an enclosure, adequate space for air circulation
is required. The
space above, below and at both sides should be at least 5 cm.
Avoid extreme environmental conditions and protect the device from dust, hu-
midity and heat.
Due to the characteristics and physical principles inside flash memory, SSDs have a
finite lifetime dictated by the number of write operations. Therefore, take care of
the regular write operations to prevent an early SSD damage. Ask for the technical
data of the used SSD and, if necessary, for support to calculate the lifetime. Inform
the user of the system that SSDs are wear parts which must be renewed regularly.
IMAGO Technologies GmbH
Strassheimer Str. 45; 61169 Friedberg - Germany; Tel. +49 6031-6842611
info@imago-technologies.com;
www.imago-technologies.com
Page 3 / 21
Advertisement
Table of Contents
