Husqvarna BT 90 Operator's Manual page 13

3. Adjust the bellows (C) until the end of the joint (D)
shows.
C
D
4. Install the joint to the product and install the screw
(E).
5. Install the clamps (F).
F
F
992 - 002 - 11.10.2023
6. Move the truss screed sections together until nut (H)
E
7. Turn the nut (H) with a 36 mm wrench.
8. Make sure that the plugs (K) are aligned.
9. Tighten the nut (H) fully
10. Tighten the nuts (I and J) with a 36 mm wrench.
11. Tighten the nuts (A) with 2 flat 19 mm wrenches.
To install the skates (optional)
1. Put the product with the top side down.
goes into the holder (G).
I J
H
G
Note:
The nut has a right hand thread.
A
K
A
13