BMW XM Owner's Manual page 143

Additional information:
Antilock Braking System, refer to page 209.
Assisted Driving Mode
Warning light illuminates and acoustic
signal sounds: A system interruption is
imminent.
Warning light flashes: A lane boundary has
been crossed.
Additional information:
Assisted Driving Mode, refer to page 234.
Assisted Driving Mode: Hands are not
on steering wheel
Hands are not grasping the steering
wheel. The system is still active.
Grab the steering wheel with your
hands.
Additional information:
Assisted Driving Mode, refer to page 234.
Dynamic Stability Control
Warning light flashes: Dynamic Stabil-
ity Control is regulating the driving and
brake power. The vehicle is stabilized.
Reduce the vehicle speed and adjust your driv-
ing style to the road conditions.
Warning light illuminates: Dynamic Stability
Control has malfunctioned or is initializing.
Driving stabilization is restricted or has failed.
If the warning light illuminates continuously,
have the vehicle checked immediately by an
authorized service center or another qualified
service center or repair shop.
Additional information:
Dynamic Stability Control, refer to page 214.
Online Edition for Part no. 01405A8A608 - VI/23
Displays
Dynamic Stability Control deactivated
The Dynamic Stability Control is deac-
tivated or the M Dynamic Mode is acti-
vated.
Additional information:
▷ Dynamic Stability Control, refer to
page 214.
▷ M Dynamic Mode, refer to page 215.
Flat tire monitor
Warning light illuminates: Flat tire or
tire pressure loss has been detected.
Reduce your speed and stop cau-
tiously. Avoid sudden braking and steering
maneuvers.
Additional information:
Flat tire monitor, refer to page 356.
Tire pressure monitor
Warning light illuminates: Flat tire or
tire pressure loss has been detected.
Follow the information in the Check
Control message.
Warning light flashes then illuminates continu-
ously: Flat tires or tire pressure losses cannot
be detected.
▷ Fault caused by systems or devices with
the same radio frequency: after leaving the
area of the interference, the system auto-
matically becomes active again.
▷ In the case of tires with special appro-
val: the tire pressure monitor was unable
to complete the reset. Reset the system
again.
▷ Wheel without wheel electronics installed:
Have it checked by an authorized service
center or another qualified service center or
repair shop as needed.
▷ Malfunction: have the vehicle checked by
an authorized service center or another
qualified service center or repair shop.
CONTROLS
143