OPERATION INSTRUCTIONS External Mix Air Nozzle Application OPERATION: Connect hose as shown in diagram. Fill cup with strained fluid mixed in accordance with manufacturer's recommendations on label of container. Fasten cover securely. Close air adjusting valve by turning clockwise. Set air pressure at oil and water extractor (transformer) to between 35 and 80 P.S.I., depending upon atomization desired.
Page 3
IMPORTANT: The most efficient atomization air pressure is the lowest air pressure that will properly atomize the paint. This will minimize the overspray, deposit more paint on the surface and eliminate paint wastage. If a faster coverage is necessary, first increase fluid pressure and then adjust atomization air pressure. If a slower coverage is more desirable, first reduce the fluid pressure and then adjust atomization air pressure.
DECLARATION OF CONFORMITY SUMAKE INDUSTRIAL CO., LTD. 4F, No. 351, Yangguang St., Neihu District, Taipei City, Taiwan declare in sole responsibility that the equipment Equipment: 2 LITERS PAINT TANK WITH SPRAY GUN Model/ Serial No.: SS-1170 to which this declaration applies, complies with these normative documents: ...
SS-1170(S) SPRAY GUN SS-1180(S) SPRAY GUN PARTS LIST Parts No. Description Q'ty Parts No. Description Q'ty 1170S-01 Air Nozzle W/Brass Cap 1170S-22 Housing 1170S-04 Fluid Nozzle -1.0 1170S-23 Paint Needle Complete -1.0 1170S-04A Fluid Nozzle -1.8 1170S-23A Paint Needle Complete -1.8 1170S-04B Fluid Nozzle -2.0...
Page 6
SS-1170(T) 2 LITERS PAINT TANK PARTS LIST Parts No. Description Q'ty 1170T-01 5/16 Hex Jam Nut 1170T-02 No.6-32 x 1/4 Rd. Hd. M.Screw 1170T-03 Check Valve Washer 1170T-04 Center Post Assembly 1170T-05 Cup (2 Qt.) 1170T-06 Cover Gasket (Rubber) 1170T-07...
SPRAY GUN Original instructions SUMAKE Industrial Co. Ltd.
Page 8
The tool has been manufactured in conformity with the instruction of EU machine directive. The EU mark will be considered void in the event of inexpert repairs, the use of non-original parts and in case of non-observance of the safety instructions in the user’s manual. Possible direct or indirect consequential damages are not the responsibility of SUMAKE Industrial co., Ltd. General safety rules: Watch the tool at all times when in use.
Page 9
Safety precautions for repetitive motions hazards 1. When using the tool, the operator may experience discomfort in the hands, arms, shoulders, neck, or other parts of the body. 2. While using the tool, the operator should adopt a comfortable posture. Maintain secure footing and avoid awkward or off-balanced postures.
Page 10
General preparation and connection: Before connecting the air hose, apply 4 to 5 drops of SAE#10-20 spindle oil at the air inlet. Also, every 3 to 4 hours of operation, oiling is necessary. Twist Teflon thread tape to ensure a proper seal air inlet. Then tighten the air coupler into air tool. The supplied compressed air must be clean and dry, with the appropriate oil mist.
Need help?
Do you have a question about the SS-1170 and is the answer not in the manual?
Questions and answers