Buzzer Sound Control; Start Program; Factory Settings - Danby DDW1832ESS Owner's Manual

OPERATING INSTRUCTIONS
To change how much rinse aid is being dispensed
with every wash, follow the steps below.
1. Turn the the appliance on and press the menu
button for 3 seconds.
2. Press Delay(+)button to access Rinse Aid setting.
3. r:4 will appear on the display as it is the default
setting.
4. Press Select button and the level of Rinse aid
(e.g. "r:4") blinks.
5. Change the level by pressing the Delay buttons.
6. Press Select button to save desired level and the
new level will illuminate constantly.
7. Turn off the appliance to exit from the setting.
Level Dose
r:1 no rinse aid
r:2 1 dose
r:3 2 doses
r:4 3 doses
r:5 4 doses

START PROGRAM

To change the start program selection, follow the
rinse aid setting steps.
In "LP0" the appliance turns on with the Eco
program.
In "LP1" the appliance turns on with the last selected
program and option.
SAVE POWER MODE (selected models)
To change the save power mode setting, follow the
rinse aid setting steps.
In "SP0" the interior lights (if available) will always
be off, the screen will turn off after 4 minutes and
will turn off after 15 minutes of no activity.
In "SP1" the interior lights will turn off after 4
minutes when the door is opened, the screen will
turn off after 15 minutes of no activity.
In "SP2" when the appliance is in the off position,
interior lights will turn off after 4 minutes when the
door is opened. When the appliance is in the on
position, interior lights are on as long as the door
stays open and the appliance will not urn off except
by pressing the On/Off button.
Note: If the dishes are
not drying properly or
are spotted, increase the
level.
If there are blue stains on
the dishes, decrease the
level.

BUZZER SOUND CONTROL

To change the buzzer sound, follow the rinse aid
setting steps until the display shows "b:3" which is
the highest sound level.
Display
b:0
b:1
b:2
b:3

FACTORY SETTINGS

To change the factory setting, follow the rinse aid
setting steps.
"FS1" will return all settings to factory default.
INFOLED
Not available on all models.
An LED is located on the bottom side of the
dishwasher which shines a light on the floor to
indicate the current status of the dishwasher during
a selected program.
LED Indicator
Red,
continuous
Red,
flashing
Red,
flashing rap-
idly
Green,
continuous
6
Level
no sound
low sound
medium sound
high sound
State of Appliance
Program is running
Program is cancelled
Appliance has a fault
Program has completed