Technics RS-TR474 Service Manual page 3

| RS-TR47
Mi CONNECTIONS
¢ For (P, PC) areas
Before making connections, make sure that the power to this unit
and all other system components is turned off first.
Stereo connection cable
White (L)
Red (A)
Avoid letting the cables touch each other as much as possible,
Receiver otherwise noise will be generated.
'or amplifier
Placement hints
ac OUTLETS
Household AC outlet
{AC 120 V, 60 Hz)
"AC OUTLET" (UNSWITCHED)
Power is always available, regardless of the unit's power
switch setting.
Audio equipment rated up to 100 W can be connected.
Connect this cord after
ail other cables and
cords are connected.
¢ For others
Before making connections, make sure that the power to this unit
and all other system components is turned off.
¢ Avoid letting the cables touch each other as much as possible,
otherwise noise will be generated.
¢ Although the figure below shows the AC power supply cord be-
ing connected to a household AC outlet, if the amplifier (or
receiver) is equipped with an AC outlet. connect the cord to that
outlet.
Placement hints
If this unit is placed near a receiver or a tuner, a "hum" noise
may be heard during tape playback, recording, or AM reception
of the receiver or the tuner.
If this occurs, leave as much space as possible between the
units, or place them where there is the least amount of "hum".
Stereo connection cable
White (L)
Rea {R}
This unit
seer this cord after
For (EB) area only
BE SURE TO READ THE CAUTION FOR AC
POWER SUPPLY CORD ON PAGE 3
BEFORE THE FOLLOWING CONNEC-
TIONS.
Household
AC outlet