Controls And Connectors; Introduction; Front Panel Controls - Tektronix 214 Manual

Operating Information
214 Service (SN B300000 & ABOVE )
Controls and connectors necessary for operation of the
214 are located on the front and right side panels of the
instrument. The power on off switch is located on the lower
left side of the instrument . Vertical controls are color-coded
with the tip of the corresponding probe . To make full use of
the capabilities of this instrument, the operator should be
familiar with the function and use of each control and
connector.
8
2-2
CONTROLS AND CONNECTORS
INTRODUCTION
B A D
2 3
999999999
4
5
FRONT PANEL CONTROLS
1 ) READY LED - Indicates sweep has been reset and a
single display will be presented upon receipt of an
adequate trigger signal.
COMMON and probe ground straps are electrically
connected. Therefore, an elevated reference applied
to any ground is present on the others-as indicated by
the yellow warning bands under the probe retractable
hook tips, and the ground strap protective coverings.
6
Figure 2-1 . Front panel controls.
WARNING
1
1 )
L
5054-02
2 ) SINGLE SWP - When pushed , the sweep operates in
the Single Sweep mode . After a sweep is displayed ,
further sweeps cannot be presented until the RESET
button is pressed and released . Automatic Enhance
occures in SINGLE SWP storage at sweep rates of
0.1 ms/div and above.