Troubleshooting - Solt GGSRCB900BS User Manual

Troubleshooting

For Minor Faults
Problem
The lights can be turned on,
however the motor does not.
Both the light and motor do not
work properly.
The light is not working.
The is insufficient suction power or
air is not extracted adequately.
The rangehood is vibrating against
the wall or cabinetry.
Oil is leaking from the rangehood.
The rangehood inclines.
For Serious Faults
• Some minor faults can be fixed by referring to the table
above, however if an emergency or serious fault occurs,
immediately disconnect the rangehood from your
electricity supply and contact After Sales Support.
• If a serious fault occurs, DO NOT attempt to repair the
rangehood yourself, instead wait for an authorised
service agent or similarly qualified person to do so.
GGSRCB900BS
Possible Cause
The fan switch, the motor or the
capacitor may be damaged.
The blades may be blocked.
The fuse or light may be damaged.
The power supply cord may be loose
or disconnected.
The light globes may be damaged or
may have blown.
The distance between the rangehood
and the cooktop may be too great.
Ducting may be loose, kinked, be too
long or have too many bends.
The rangehood body may not be fixed
in place correctly.
The motor may not be tightly hung.
The fan blade may be damaged.
Outlet and the air ventilation entrance
are not tightly sealed.
Leakage from the connection of
U-shaped section and cover.
The fixing / hanging screws are loose.
• For assistance or to organize an authorised service agent
contact our After Sales Support by calling 1300 11 4357,
or by emailing support@residentiagroup.com.au.
• Please note that if a service agent is asked to attend
whilst the product is under warranty and finds that the
problem is not the result of an appliance fault, then you
may be liable for the cost of the call out charge.
Solution
Call our After Sales Support Team for
further guidance.
Call our After Sales Support Team.
Reset or replace the fuse or light.
Reconnect the power supply to the
wall socket.
Call our After Sales Support Team for
further guidance.
Re-adjust the installation position,
ensuring that the minimum distances
are observed as per page 09.
Check that your rangehood has been
ducted correctly and in accordance
with the installation instructions.
Fix the body tightly and ensure that all
installation steps are done correctly.
Lock in the motor tightly.
Call our After Sales Support Team.
Carefully take down the outlet and
re-seal with glue.
Take U-shaped section down and seal
with soap or paint.
Tighten the fixing or hanging screws.
14