Oase 33885 Operating Instructions Manual page 18

Operating conditions indicated by the Status LED
LED
–
Green
Yellow
Green+ yellow Lit
Red
Service button functions
Operation
Press and hold for 5 seconds until
the green LED begins to flash.
Press and hold for 15 seconds until
the yellow LED begins to flash.
18
LED status Description
Off The Aquarium Controller is switched off.
Lit A direct connection is established.
Flashing slowly A connection to a WiFi network is established.
(1× per second)
Lit The Aquarium Controller is starting.
Flashing slowly The Aquarium Controller is attempting to establish a connection to
(2 s on, 1 s off) the router. This can take several minutes.
• If no connection is found, check the WiFi connection. If necessary,
The Aquarium Controller is in firmware update mode.
Green is lit, yellow is A firmware update is in progress.
flashing
Flashing An internal error has occurred; recommended procedure:
• Disconnect the power supply, wait for approx. 10 seconds, then re-
• If the error remains active, ...
Description
Reset network settings.
• When the button is released, the green LED extinguishes and the
• The network settings are reset to the delivery default settings.
• All other settings are maintained (e.g. device list and device set-
Reset to factory settings.
• When the button is released, the green LED extinguishes and the
• All settings are reset to the delivery default settings.
reduce the distance between the Aquarium Controller and the
router.
establish the power supply.
− use the "OASE Control" app to check for new firmware. If neces-
sary, install new firmware.
− reset the device to its factory settings and restart it. (→ Service
button functions)
− contact the OASE service.
yellow LED lights up for approx. 5 seconds. Then the yellow LED ex-
tinguishes and the green LED lights up.
tings).
yellow LED lights up for approx. 10 seconds. Then the yellow LED ex-
tinguishes and the green LED lights up.