Homewhiz Setup - Hitachi BD-90YFVEM Instruction Manual

In order to use the Bluetooth feature of your
machine, you must download HomeWhiz
application from the application store of
your smart appliance.
Make sure your smart appliance is connec-
ted to the internet to install the application.
If you are using the application for the first
time, please follow the instructions on the
screen to complete your user account re-
gistration. Once the registration procedure
is complete, you can use all products with
the HomeWhiz feature in your house on
this account.
You can touch the "Appliances" tab in the
HomeWhiz application to view appliances
paired with your account. Following the in-
stallation of the application, HomeWhiz
function enables the washing machine to
send you instant notifications via your
smart appliance.
In order to use the HomeWhiz func-
tion, the application must be in-
stalled on your smart appliance,
and your washing machine must be
paired with your smart appliance
via Bluetooth. If your washing ma-
chine is not paired to your smart
device it works as an appliance
which does not have a HomeWhiz
feature.
Your product will operate as paired
to your smart device via bluetooth.
The controls made by means of the
application will be enabled through
this pairing. Therefore the
bluetooth signal strength between
the appliance and the smart device
must be adequate.
Please visit
see the Android and iOS versions
supported by the HomeWhiz applic-
ation.
to
www.homewhiz.com
All the safety measures described
in "GENERAL SAFETY INSTRUC-
TIONS" section of your user
manual apply to the remote opera-
tion through HomeWhiz function as
well

6.15.1 HomeWhiz Setup

In order run the application, a connection
must be established between your appli-
ance and HomeWhiz application. In order
to establish this connection, you must fol-
low the steps given below for the setup pro-
cess on both your appliance and the Home-
Whiz Application.
1. If you are adding a device for the first
time, touch "Appliances" tab on the
HomeWhiz Application. Select "ADD AP-
PLIANCE" (touch here for setting up a
new appliance) button in the upper right
corner. Perform the setup by following
both the steps below and the steps in
the HomeWhiz Application.
2. To start the setup, make sure that your
machine is turned off. Press and hold
the Temperature button and the Remote
Control Function button simultaneously
for 3 seconds to switch your machine to
HomeWhiz setup mode.
3. When the appliance is in HomeWhiz
setup mode, you will see an animation
on the display and the bluetooth icon
will flash until your machine gets paired
with smart device. Only programme
knob will be active in this mode. Other
buttons will be inactive.
EN / 32