Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Kuppersbusch IGVS6509.5
Summary of Contents for Kuppersbusch IGVS6509.5
- Page 1 IGVS6509.5...
-
Page 3: Table Of Contents
Table of contents Intended use ....4 Utensils ....14 Not suitable. -
Page 4: Intended Use
Intended use End of programme ....24 Intended use Automatic switch off / interior light . . 25 Switching off the appliance..25 I n t e n d e d u s e This appliance is intended for... -
Page 5: Before You Switch On The Appliance
Safety instructions Keep children below the age of Installation 8 years old at a safe distance Following installation, ensure from the appliance and power that the back cable. of the dishwasher is not freely accessible (protection Before you switch ON the against contact due to hot appliance surface). -
Page 6: In Daily Use
Safety instructions If the dishwasher is installed Do not install the appliance below or above other near heat sources (radiators, domestic appliances, follow heat storage tanks, cookers the information for installation or other appliances which in combination with generate heat) and do not a dishwasher install under a hob. -
Page 7: Door Lock
Safety instructions Childproof lock (door lock) Warning D o o r l o c k Risk of injury! The description of the childproof lock is at the back in To prevent injuries, e.g. the envelope. caused by stumbling, open the dishwasher only briefly * depending on model in order to load and unload the dishwasher. - Page 8 Safety instructions Ensure that children do not Warning place fingers in the tablet Risk of scalding! collecting tray 1:. Small Open the door carefully when fingers could become the programme is still running. caught in the slots. There is a risk of hot water When opening and closing spraying out of the appliance.
-
Page 9: Protection Of The Environment
Protection of the environment Protection of the Getting to know your environment appliance i o n P r o t e c t o f t e n v i r o n m e n t G e t t i t o k n o w y o u r a p p l i a n c... -
Page 10: Appliance Interior
Water softening system/Special salt Appliance interior Water softening system/Special salt 1" Interior light * W a t e r s o f t e n i s y s t e m / S p e c i s a l t 1* Top basket To ensure good washing results, 12 Knife shelf *... -
Page 11: Water Hardness Table
Water softening system/Special salt To change the setting: Using special salt 1. Press programme button 3. Always refill with special salt Each time the button is pressed, the immediately before switching on the set value increases by one level; appliance. This ensures that overrun when the value of : has been special salt solution is immediately... -
Page 12: Detergents With Salt Component
Rinse aid Using detergents with salt Rinse aid component D e t e r g e n t s w i t h s a l t c o m p o n e n t R i n s e a i d As soon as the rinse-aid refill If combined detergents with a salt... -
Page 13: Setting Amount Of Rinse Aid
Rinse aid 3. Close cover until it clicks shut. Switching off rinse aid refill 4. To prevent excessive foam formation indicator during the next rinse cycle, remove any rinse aid which has run over with If the rinse-aid refill indicator H is a cloth. -
Page 14: Utensils
Utensils Loading the dishwasher Utensils U t e n s i 1. Remove large food remnants. It is not necessary to prerinse utensils Not suitable under running water. 2. Place the utensils so that Cutlery and utensils made of wood. –... -
Page 15: Cups And Glasses
Utensils Cups and glasses Pans Top basket 1* Bottom basket 1j Note Utensils must not be placed above the Heavily soiled utensils (pans) should tablet collecting tray 1:. These may be placed in the bottom basket. The block the lid of the detergent dispenser more powerful spray jet provides and prevent it from opening fully. -
Page 16: Cutlery Basket
Utensils Cutlery basket F olding spikes * F o l d i n g s p i k e s You should always place cutlery * depending on model unsorted with the points downwards. The spikes can be folded down to To prevent injuries, place long, pointed improve arrangement of pans, bowls implements and knives on the knife... -
Page 17: Knife Shelf
Utensils Knife shelf * Top basket with side levers K n i f e s h e l f 1. Pull out the top basket 1* out. * depending on model 2. To lower the basket, press in the left Long knives and other utensils can be and then the right lever on the arranged horizontally. -
Page 18: Detergent
Detergent Adding detergent Detergent 1. If the detergent dispenser 9* is still D e t e r g e closed, press the lock 92 to open You can use tablets as well as powder the detergent dispenser. or liquid detergents for dishwashers, but never use washing up liquid. -
Page 19: Combination Detergent
Detergent Notes If the utensils are only lightly soiled, You will obtain optimum rinsing slightly less than the indicated amount and drying results by using solo of detergent is usually adequate. detergents and applying salt and rinse aid separately. Suitable detergents and care products If programmes are short, tablets can be purchased online may not have full cleaning effect... -
Page 20: Overview Of Programmes
Overview of programmes Overview of programmes p r o g r a m m e s O v e r v i e w o f The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia. -
Page 21: Programme Selection
Additional options Programme selection Additional options o n a l A d d i t i o p t i o n s You can select a suitable programme according to the type of utensils and * depending on model degree of soiling. -
Page 22: Hygiene
Operating the appliance · Hygiene * Operating H y g i e n e the appliance The temperature is increased during the cleaning process. This increases the O p e r a t i i a n c e t h e a p p l hygiene status. -
Page 23: Eco Drying
Operating the appliance 4. Press the START button `. To change the setting: 1. By pressing the 3 button, you can 5. Close the door. switch Eco drying on : or off The programme starts running. Note 2. Press START button `. - for environmentally friendly operation The set value is saved. -
Page 24: Remaining Running Time Display
Operating the appliance To change the setting: T imer programming * T i m e r p r o g r a m m i n g 1. Open the door. 2. Switch on ON/OFF switch (. * depending on model 3. -
Page 25: Automatic Switch Off / Interior Light
Operating the appliance To change the setting, 1. Open the door. 1. Press programme button 3. Each 2. Switch on ON/OFF switch (. time the button is pressed, the set 3. Hold down programme button # value increases by one level; when and press START button ` the value of : has been reached,... -
Page 26: Interrupting The Programme
Operating the appliance worktops from damage by water vapour. Changing the programme Before opening the appliance, leave it to cool down for a while in the When the START button ` has been remaining programmes when the pressed, the programme cannot be programme ends. -
Page 27: Cleaning And Maintenance
Cleaning and maintenance Never use a steam cleaner to clean your Cleaning and dishwasher. The manufacturer is not liable for any consequential damage. maintenance Regularly wipe the front of the appliance C l e a n i a n d n a n c e m a i n t e and fascia with a damp cloth;... -
Page 28: Filters
Cleaning and maintenance Filters Spray arms The filters 1Z keep large foreign Limescale and contaminants in the objects in the rinsing water away from rinsing water may block nozzles and bearings on the spray arms 1B and the pump. These foreign objects may occasionally block the filters. -
Page 29: Fault, What To Do
Fault, what to do? In this case: Fault, what to do? 1. First always disconnect F a u l t , w h a t d o ? the appliance from the power supply. Experience has shown that you can 2. -
Page 30: Fault Table
Fault, what to do? Fault table Fault Reason Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display 8 lights up. Tap turned off. Turn on the tap. Tap jammed or calcified. Turn on the tap. Flow rate must be min. - Page 31 Fault, what to do? Fault Reason Remedial action Error code : is lit. Waste water pump blocked or Clean pump and lock cover correctly. (See cover on the waste water pump is “Waste water pump”) not locked in position. Error code : is lit.
- Page 32 Fault, what to do? Fault Reason Remedial action Utensils not dry. No or too little rinse aid in the Refill rinse aid. dispenser. Programme selected without Select programme with drying (see drying. “Overview of programmes”, “Programme sequence”). Water collecting in depressions Arrange utensils in a sloping position, on the utensils and cutlery.
- Page 33 Fault, what to do? Fault Reason Remedial action Food remnants on the Utensils placed too closely Arrange utensils with adequate clearance utensils. together, utensils basket between them ensuring that the spray jets overfilled. can reach the surface of the utensils. Prevent contact points.
- Page 34 Fault, what to do? Fault Reason Remedial action Water stains on plastic Droplet formation on plastic Use a more intensive programme (more parts. surface is physically unavoidable. water changes). After drying, water stains are Arrange utensils in a sloping position. visible.
- Page 35 Fault, what to do? Fault Reason Remedial action Coloured (blue, yellow, Film formation consisting of Can be partly removed with machine brown), difficult to remove ingredients from vegetables (e.g. cleaner or by mechanical cleaning. Coatings to non-removable coatings cabbage, celery, potatoes, are harmless.
- Page 36 Fault, what to do? Fault Reason Remedial action Initial or existing, Glasses not dishwasher-proof, Use dishwasher-proof glasses. irreversible clouding of only suitable for dishwasher. Avoid long steam phase (standing time after glass. wash cycle ends). Use wash cycle at lower temperature. Set water softening system according to the water hardness (if required one setting lower).
- Page 37 Fault, what to do? Fault Reason Remedial action Door does not open Eco drying deactivated. Activate Eco drying (see chapter “Operating automatically at the end of the appliance”). the Eco 50° programme. Button lock has been activated. * Deactivate button lock (see chapter “Safety information”).
- Page 38 Fault, what to do? Fault Reason Remedial action Appliance stops in the Door not closed properly. Close the door. programme or programme Do not place utensils or fragrance Check whether rear panel is being pressed is interrupted. dispenser in the tablet collecting in, e.g.
-
Page 39: Customer Service
Customer service Customer service Installation and connection C u s t o m e r s e r v i c e If you are unable to rectify the fault, l a t i o n I n s t a l a n d c o n n e c t i please contact your customer service. -
Page 40: Delivery
Installation and connection Delivery Installation Your dishwasher has been checked The required installation dimensions can thoroughly in the factory to ensure that it be found in the installation instructions. is in working order. This may cause Level the appliance with the aid of the small water stains. -
Page 41: Drinking Water Connection
Installation and connection Drinking water connection Setting hot water: 1. Open the door. 2. Switch on ON/OFF switch (. 1. Fasten the drinking water connection to the tap according 3. Hold down programme button # to the installation instructions using and press START button ` the enclosed parts. -
Page 42: Removing The Appliance
Installation and connection 8. Press START button ` until : Use only a residual current operated circuit-breaker which features is indicated on the digital display. the symbol ‚. Only this extension 9. Close the door. guarantees compliance with 10. Open door after approx. 1 minute. the currently valid regulations. - Page 44 K09-180011/02 *9001186172* 9001186172 (9602) 640MV...
Need help?
Do you have a question about the IGVS6509.5 and is the answer not in the manual?
Questions and answers