Installation Preparation; Materials You Will Need; Tools You Will Need - GE PDW8000 Installation Instructions Manual

MATERIALS YOU WILL NEED:

Materials Required for All Installations
90° Elbow (3/8"NPT external thread on one end, opposite
end sized to fit water supply)
Note: Use new ferrule. Do not use old parts.
Strain relief for electrical connection
Thread seal tape
UL Listed wire connectors (3)
Screw type hose clamps
Materials For New Installations Only:
Air gap for drain hose, if required
Waste tee for house plumbing, if applicable
Electrical cable or power cord, if applicable
Hand shut-off valve (recommended)
Water line 3/8" min. copper or 1/2" min. plastic (plastic
must be tested for temperature and pressure)
Coupler for extending drain line, if applicable

TOOLS YOU WILL NEED:

Tools Required for All Installations
Phillips head and flat blade screwdrivers
3/8", 5/16" and 1/4" nutdrivers
Level
Carpenters square
Measuring tape
Safety glasses
Flashlight
Bucket to catch water when flushing the line
Tubing cutter
Gloves to protect against sharp edges
Wire strippers
For New Installations Only:
Drill and appropriate bits
Hole saw set
Gloves

Installation Preparation

Safety Glasses
Wire Strippers
Bucket
Measuring Tape
Level
90° Elbow
Thread Seal
Tape
Waste Tee
Air
Gap
Flat Blade Screwdriver
Adjustable
Wrench
4
Screw Type Clamps
Wire Nuts
Shut-Off
Electrical Cable
Valve
or Power Cord
Coupler
Hot Water Line
Phillips Head
Screwdriver
Flashlight
Drill
and Bits
Hole
Saw Set
Strain Relief
Nut Driver
Tubing
Cutter
Square