Table of Contents
Advertisement
45 DEGREE
INWARD POSITIVE STOP
To check the accuracy ot the positive stops at 45 degree
inward angle of lilt, position the fence (E) Fig. 22, inward as
far as possible. Use a combination square (D), and check
to see if the fence is tilled inward accurately at 45 degrees.
If an adjustment is necessary, proceed as follows:
I. Loosen lockhandle (C) T ig. 22.
2.
Loosen locknut (A) Fig 23. and turn adjustment screw
(B) until the fence (E) is set accurately at 45 degrees to the
table surface.
3.
Hetighten locknut (A) Fig. 23.
45 DEGREE
OUTWARD POSITIVE STOP
To check the accuracy of the positive stops at tho 45 degree
outward angle ot tilt, position the fonco (E) Fig. 24, outward
as faras possible. Use a combination square (D) arid check
to see it the fence is tilted outward accurately at 45 degrees
ll an adjustment is necessary, proceed as follows:
1.
Loosen lockhandle (C) Fig. 24.
2.
Loosen locknut (K) Fig. 24. and turn adjustment screw
(L) until the fence (E) is set at 45 degrees with the table
surface.
3.
Retighten locknut (K) Fig. 24. and lockhandle (C).
E
/
Fig. 24
I
12
Advertisement
Table of Contents
