Easygo™ Ramp Operation - Renault Autograph User Manual

RENAULT
fig.1
fig.2
a
fig.3
fig.4
fig.5
EasyGo™ Ramp Operation
The EasyGo™ ramp is a single action ramp. When not
in use it is stored vertically at the rear of the vehicle.
Deploying the ramp
A.
To release the ramp pull the lever on the underside of
the main ramp body
B.
Using the handle in the centre of the ramp, pull the
ramp out towards you. The ramp will lower
draw it out. Once fully lowered, the ramp is ready to
use
fig.3
Stowing the ramp
A.
Using the handle on the side of the ramp
the ramp and walk it back into it's upright position
. To reduce the height of the ramp when
fig.4
travelling, the top section folds down flat against the
main part of the ramp
B.
Latches on either side of the ramp secure it in
position. Once latched, pull on the ramp to check that
it is secured.
IMPORTANT NOTE
Ensure the top section of the ramp is folded down before
travelling. Otherwise rearward vision will be reduced and
damage to the rear window may occur.
Please ensure the ramp is fully extended and rests on a
stable and level surface when in use. Pay careful attention
when boarding and alighting via the ramp if your vehicle is
parked on a slope or a steeply cambered road, particularly
when facing uphill, as this increases the angle of the ramp.
While the ramp surface is slip-resistant , extra care should
be taken when operating in wet conditions.
When parking, leave enough room at the rear of the
vehicle for wheelchair entrance and exit (approx. 3
metres to the nearest obstacle).
Freephone 0800 587 9656
www.alliedmobility.com
™
.
fig.1
.
.
fig.5
page 3
USER GUIDE
as you
fig.2
, lift up
fig.3a