After Use - Panasonic NI-GT150 Operating Instructions Manual

generated in a short time (about 2 seconds).
◆ Automatic shut-off
When the product is not operated within 10 minutes or the
product uses only dry ironing continuously for 10 minutes, the
product will be automatically powered off.
To restart the product, press the power button again.
Notes:
a. During use, a few drops of water and steam may be
ejected from the soleplate at the same time. This is
normal.
b. Do not touch the soleplate before it has fully cooled down.
c. Do not iron clothes that you are wearing.
d. Do not allow the soleplate surface to get close to yourself
or others.
e. Do not use steam when the iron is rested on the power
base in case of scalding.
f . During use, a large amount of steam will be ejected
when the steam button is first pressed and later the
amount of steam will slowly decrease and tend to be flat.
If a large amount of steam is needed, please put the iron
back to the power base and heat it for about 15 seconds.
g. After use, place the iron on the heat-insulation pad
correctly and press the iron lock to lock the iron onto the
power base.
h. When the water level of the water tank is too low, the water
shortage indicator turns on in red and remains steady on.
After water is added, the water shortage indicator turns
off.

After use

1. After ironing, place the iron on the heat-insulation pad
correctly and press the iron lock to lock the iron onto the
power base. Then, press and hold the power button until the
product shuts down and all indicators turn off, and remove
the power plug.
2. Take out the detachable water tank and pour out the
remaining water.
3. Install the detachable water tank back to the power base
and clean residual water from where the detachable water
tank is installed.
4. Store the product in a safe place.
Notes:
a. After use, remove the power plug and leave the product
to cool down for more than 60 minutes before any
cleaning or maintenance.
b. Never use such cleaning products as the thinner,
cleanser and volatile solvent to wash the product.
Otherwise, the product may be damaged.
15