Antunes IS-1000 Quick Start Manual

ANTUNES www.antunes.com 180 Kehoe Blvd., Carol Stream, Illinois 60188
The steamers weighs 125 lbs. each and require two people to lift out of the box and stack on the table. See the owners manuals for

Instructions

This Quick Start Guide is to assist in the setup of the
InfiniSteam-1000 unit and WSS-0618-ENC water filtration unit.
1.
Unbox softener, enclosure, and steamers. Remove any
protective gray film. Place the softener enclosure in the
center of the table between where the steamers stack.
2. Install the cavity drain screens, drawers and drip trays to
the steamers. Wash the amber pans and trivets.
USB
Port
Cavity Drain
Clean Cycle
Screens
Key
3. Ensure all water lines have been fitted properly to the
softener's push-to-connect fittings to prevent leaks.
O-ring provides Grips before it seals
a leakproof seal The Collet (gripper) has stainless
steel teeth which hold the tube
firmly in position while the O-ring
provides a permanent leakproof
seal.
Stainless Steel teeth
grip the pipe.
+1-877-392-7854 tech.service@antunes.com
IS-1000 and WSS-0618-ENC Quick Start Guide
specific warnings and cautions.
Steam
Trivets
Removable
Drawers
Collet
®
CAUTION
4.

Connect the inlet water line, drain hose, and output lines

that go to the steamers.
5. Plug the water softener transformer into a standard 120V
NEMA 5-15R outlet. A new outlet is recommended to
support the weight of the transformer.
6.
Add 40 pounds of water softener salt to the brine tank.
NOTE: Do not allow salt to get into the float mechanism
inside the white tube. Failure to do so will result in
water overflow.
Drip
Trays
7.

Install the white cap on the softener brine tank.

Page 1 P/N 1011715 Rev A 09/22