Bissell POWERFORCE HELIX 3313 Series Manual page 4

Cleaning the Filters & Separator
1.
Remove dirt tank by
pressing release button and
lift tank away from vacuum.
4.
To access pre-motor filter,
lift release latch on front
of tank to lift lid.
Maintaining Your Vacuum
For more helpful maintenance tips, check out support.BISSELL.com.
Replacing the Brush and Belt
1. Unplug vacuum, turn over and unscrew five
Phillips-head screws to remove bottom cover.
2. Lift brush roll straight out. Inspect belt and
replace if it appears damaged.
3.
Replace brush roll and belt by looping the
belt over motor shaft and brush roll. Line up
the endcaps and pull brush forward into place,
stretching the belt. Replace cover and screws.
Troubleshooting
For a comprehensive walkthrough of your product and support tips, visit support.BISSELL.com.
BISSELL proudly supports BISSELL Pet Foundation® and its mission to help save homeless pets.
When you buy a BISSELL® product, you help save pets, too. We're proud to design products that help
make pet messes, odors and pet homelessness disappear. Visit BISSELLsavespets.com to learn more.
4
2.
With dirt tank removed,
press filter cover release
button to access post-motor
filter.
5.
Remove pre-motor filter
from tank lid. Clean with
warm water and allow to dry
completely before reinserting.
Every Purchase Saves Pets
©2023 BISSELL Inc. All rights reserved.
Part Number 1629463 11/22 RevB
3.
detergent, rinsing and
squeezing to remove water.
Allow filters to dry completely
before reinserting.
6.
by twisting counterclockwise.
Pull out through the bottom.
Rinse and dry with a cloth.
Clearing a Clog
1.
Remove hose from back of vacuum by twisting
it to the left. Remove any debris.
2.
Check foot hose on the back of vacuum
towards bottom. If necessary, remove screw from
foot hose and check for clogs.
3. Check air passageway on bottom of vacuum.
Remove bottom cover and brush. Remove any
debris.
Clean filters with mild
Remove separator from tank
™