Hawkeye Mfg Firefly 8S How To Reset

Zeb revo/revo rt zeb came reset

Hide thumbs Also See for Firefly 8S:

ZEB Revo/Revo RT ZEB Came Firefly 8S reset

Overview

This article explains how to reset the ZEB Cam for ZEB Revo or ZEB Revo RT - Firefly model 8S.

Note: Please check your camera model first to make sure you are following the correct procedure. If you're not sure

which ZEB Cam version you have, check out this article first:

Identifying ZEB Cam Model on ZEB Revo / Revo

RT.

1. Remove the camera retaining screw using a 4mm hex key.

https://knowledge.faro.com/Hardware/GeoSlam/ZEB_Revo_and_Revo_RT/ZEB_Revo_Revo_RT_ZEB_Came_Firefly_8S_reset

Updated: Wed, 11 Oct 2023 20:02:58 GMT

Table of Contents

Do you have a question about the Firefly 8S and is the answer not in the manual?

Page 1 ZEB Revo/Revo RT ZEB Came Firefly 8S reset Overview This article explains how to reset the ZEB Cam for ZEB Revo or ZEB Revo RT - Firefly model 8S. Note: Please check your camera model first to make sure you are following the correct procedure. If you're not sure...
Page 2 2. Remove the camera from the frame. 3. Remove the SD card from the camera. 4. Power on the camera by pressing the Power/Mode button on the front of the camera. 5. Ensure the camera is set to video mode. Short press the Power/Mode button on the front of the camera to cycle between video mode and camera mode.
Page 3 6. Enter the camera settings menu page by clicking the forward button on the side of the camera. 7. Enter the Settings page by click the shutter button on the top of the camera. 8. Toggle to the Camera Settings sub-page by clicking the play button below the SD card slot. 9.
Page 4 11. Go back to the Camera Settings page again by pressing the forward button on the side of the camera and then the shutter button on the top of the camera. 12. Use the play button below the SD card slot to toggle between Video Settings and Camera Settings. On the Video Settings sub-page make the following changes: Video Settings Video Settings...
Page 5 Camera Settings Camera Settings Changes from the Default Quick Capture LCD brightness LOW (to save battery life) Auto Shutdown Screen Off Time Setup Change as Required Language Change as Required 14. Press the Power/Mode button to exit the settings page. 15.