Installing Accessories - GET SX1 PRO 4T Manual

D. INSTALLING ACCESSORIES
SX1 CONTROLLER INSTALLATION
1.
Install the SX1
CONTROLLER on the
handlebar.
2.
Connect the ECU connector
of the GL-264-AA harness
(included in the SX1 PRO
kit) to the MAIN cable of the
control unit.
3.
Connect
CONTROLLER connector to
one of the two connectors
of the GL-264-AA harness
(included in the SX1 PRO kit).
ATTENTION
•After installation, make sure that the wiring does not impede
the free movement of the handlebars in either direction or
interfere with the moving components of the motorcycle (for
example, the transmission) or inconvenience the rider (for
example, in the boot area).
•The unused connector of the GL-264-AA harness will later be
used to connect SX1 CONNECT (see the next point of the SX1
CONNECT INSTALLATION instructions).
•Consult the dedicated manual for instructions on how to
activate, set and adjust the functions of the SX1 CONTROLLER.
EN
the SX1
8
CONTROL
UNIT
SX1 CONTROLLER
ECU HARNESS
GL-264-AA
HARNESS
GL-264-AA