Advertisement
[Operation Example]
Using the remote control unit of your VCR to program the playback
command:
© {t is recommended that the name of the key and its function cor-
respond. This is convenient when operating equipment.
Learn (6)
USE
LEARN
oe
© TRANemrr
VIDEO
AUEIO
eee
AUX
ce]
oY
Co
oo
fe=) om
te el
@ LEARN indicator
This indicator shows the remote control unit operating condition.
LIT:
Learning is possible.
OFF:
Regular remote control functions are performed.
FLASHING:
;
Means the key is not available for programming a new command in the
current mode.
@ TRANSMIT indicator
This indicator flashes when remote control signals are sent.
@ LEARN selector switch
Set as follows:
LEARN:
This position is used for storing the codes of your remote control unit.
USE:
Set to this position after codes have been stored in the LEARN posi-
tion. Set to this position for normal operation.
60
an
[Operation example}
1. Set the LEARN switch of the programmable remote control unit to
the LEARN position and set the TRANSMIT mode selector switch
to the VIDEO position.
© Programming
is possible with the TRANSMIT
mode
selector
switch in any position, but VIDEO is used as an example.
2. Place the transmission sections of the programmable remote con-
trol unit and the remote control of the VCR facing each other.
1 to 2 inches
— 4
4
© Place the two units on a table, separated by 2 to
5cm (1 to 2
inches).
Memorization will not be possible if they are too close.
3.
Hold down the VCR PLAY key of the Programmable remote con-
_ trol unit until the LEARN indicator lights up, then release the key.
. "Hold down the PLAY key of the VCR remote control unit.
. Release the key of the VCR remote control unit after making sure
that the LEARN indicator has gone out on the Pioneer remote con-
trol unit.
NOTE:
:
.
i&
ee
ne
:
i
If the LEARN indicator flashes, it indicates that you are trying to preset
a key not available for the learning function. Otherwise the program ca-
pacity has been exceeded, the function programmed last will not be
memorized correctly. All previously programmed functions, however,
will be retained in memory and may be used as they are if the last func-
tion is not essential. For re-programming refer to ''Returning to the
Initial Settings."'
6. Set the LEARN selector switch of the programmable remote con-
trol unit to the USE position.
© The previous code (Pioneer uniform remote control code or code
for other equipment) is erased and replaced by the new code.
7. Check that the program works.
© Try actual operation and make sure the unit works properly.
If the VCR does not operate when pressing the key, change angle,
position and distance between the remote control units and repeat
the programming procedure.
® When programming, make sure that the function indications (for
example, =» , ==,
= ) onthe other remote control unit andthe
programmable remote control unit are the same. This will faciSi-
tate operation.
Advertisement
