Advertisement
Installation & Maintenance
Installing the Soap Dispenser
Coordinate installation with architect and contractor to avoid protrusion from opposite wall
or pipes, vents, conduits, electrical wiring, etc., in wall.
Follow all applicable local building codes. If installing where unit projects above top of
wainscot, provide aluminum channel or other filler to prevent gap from finished wall and
flange of unit. For block walls, use metal expansion shields (not included).
Prepare the wall opening to the size shown
A
in the illustration. Verify the opening has
proper backing for fasteners being used
(supplied by installer).
Open the dispenser cover.
1. Place the magnetic key (included) on the
Bradley logo and slightly push to
B
disengage the lock.
2. With the magnetic key still on the logo,
open the dispenser door.
3. Leave the magnetic key on the
Bradley logo.
Remove the soap tank/pump from the
C
dispenser by sliding forward until they stop.
Then tilt the tank/pump upwards until both
can be pulled forward out of the dispenser.
Place the dispenser inside of the wall opening
D
and position as close to the hinge side as
possible.
It is important to position the dispenser as
such to create clearance on the latch side,
allowing the latch to properly function.
Insert fasteners through the mounting holes on
E
the hinge side first, and then insert fasteners
through the mounting holes on the latch side.
F
Install the soap tank and soap pump into the
dispenser.
With the magnetic key still on the logo,
G
gently close the dispenser door. Remove the
magnetic key.
Bradley • P20-265 Rev. A: ECO 22-15-028
Elvari™ Recessed Soap Dispenser (Manual) – 6B1 Series
3-3/4"
(95mm)
Latch
Side
10/1/2023
5-3/8"
(137mm)
17-1/8"
(435mm)
Hinge Side
Mounting Holes
Soap
Tank/Pump
3
Advertisement
