Sony STR-DE598 Operating Instructions Manual page 17

Setting the voltage selector
If yonr receiver has a voltage selector on the rear
panel, check that the voltage selector is set to the
local power snpply voltage. If not, use a
screwdriver to set the selector to the correct
position before connecting the AC power cord to
a wall outlet.
120V 220V 240V
Connecting the AC power
cord
Connect the AC power cord to a wall outlet.
To a wall
outlet
Performing initial setup
operations
Be_re using the receiver _r the first time,
initialize the receiver by per_mmlg the
t_llowing procedure.
This procedure can also be used to return
settings you have made to their factory defaults.
Use the buttons on the receiver for the operation.
1
Press I/_ to turn off the receiver.
2 Hold clown I/_ for 5 seconds.
"PUSH" and "ENTER" appears in the
display alternatingly.
3 Press ENTER.
"CLEARING" appears in the display for a
while, then "CLEARED" appears.
The following are reset to their factoD-
settings.
• Al! settings in the SET UP, LEVEL,
TONE and CUSTOMIZE menus.
• The sound field memorized for each
input and preset station.
• All sound field parameters.
• Allpreset stations.
• All index names for inputs and preset
stations.
• MASTER VOLUME ,+ is set to "VOL
MIN'.
• Inpnt is set to DVD.
Q
.g
gl
_a
AC power cord
17GB